2
BEFORE BEGINNING INSTALLATION,
PLEASE READ IMPORTANT NOTES BELOW
:
•
If devices are to be powered, field installed wiring will
need to be run from thermostat location to unit location
and from door sensor location to PTAC location and from
wired magnet to sensor location.
•
If wireless platform DP01* or DL01E are being utilized,
then room numbers MUST BE CONFIGURED in the control
board prior to binding wireless devices.
•
All units must have DT01* antenna for wireless devices
to communicate properly.
Sequence of installation:
•
1) Mount the peripherals
2) Verify operation of the door sensor
3) Program room numbers
4) Bind peripherals
5) Reattach peripherals to their mounted backplates
6) Install optional security screws
•
Installation and videos are available on our website at
www.amana-ptac.com.
•
Use only one DD01E Passive Infrared Motion Sensor (PIR)
door switch combination device and/or one DS01G to one
Digi
Smart™
PTAC unit.
Antenna Installation For DT01* Kit
A DT01* antenna must be installed on the digital PTAC to
allow operation of either the DS01* remote RF thermostat
or a DD01* combination PIR motion sensor and door switch.
Preparation
1. Disconnect power to the unit by unplugging the power
cord at the wall outlet or subbase, or disconnect power
at the fuse box or circuit breaker.
2. If the cabinet front is screwed to the chassis, remove
the 1/4” screw (or screws). See following figure.
Front Mounting Screw
accessed
through louvers.
3. Remove cabinet front from chassis by tilting the bottom
of the front forward, lifting slightly up and forward.
4. Mount the antenna as high up on the control panel as
possible and as far to the right as possible in a location
that will not interfere with the reinstallation of the PTAC
polymer room front. Mark holes for screw location.
Remove antenna housing and drill two 1/8” holes where
marked. Some units may have the holes already
predrilled in the correct location.
Wire
DT01* Mounting
5. Remove antenna cable and route cable through opening
in bottom of antenna housing.
6. Mount antenna housing with two screws as shown in
figure. (
NOTE:
The Amana
®
brand logo should be in
the lower right hand corner).
7. Plug wire harness from antenna into connector on the
control board to the right of the master switch, being
careful not to bend and/or break the wires when you
connect the cable to the PTAC. Gently push the
connector into place by pushing on the edge of the
connector with your thumb nails.
Avoid pushing directly
on the wires.
8. Restore power to the PTAC unit.
9. Reinstall the polymer room cover.
NOTE:
The LED must be oriented at the
top
of the antenna
housing (the Amana
®
brand logo will be on the lower right)
for proper unit operation.
