11
If
or
does not show on the display in 1-2 seconds,
then press and release the white button a second time.
NOTE:
If both a DD01* and a DS01* are being bound,
then the display will show
.
Skip if there is no motion sensor.
4. Press “OFF” on the PTAC touchpad to exit the binding
sequence.
5. Slide top of the thermostat down onto the mounting
base plate and then snap into place.
6. Provided optional security screw may be used in the
lower center of the thermostat.
OPTIONAL SECURITY SCREW
7. Snap motion sensor onto motion sensor mounting plate.
8. Provided optional security screws may be installed on
right and left side of the sensor.
9. If you wish to change from the factory default settings,
configure the device or devices that were bound. See
the next section for configuration choices.
NOTE: If a wireless device is replaced or added, all
devices (including those previously bound) will need to be
bound/re-bound to the unit. See directions above.
