MaxTronic JanusRAID SA-6692J, Hardware User Manual

Page: 23 / 30

SA-6692J SATA II JBOD enclosure System
13
2
Ba
sic Co
nfigu
ra
tio
n –
M
oun
ting in a Rack
Mounting in a Rack
When the system is completely set up, it can be installed in a standard 19-inch rack. Fol-
low the instructions in this section to install the system in a rack.
1 Clip eight rack nuts supplied with your rack, into the rack, taking care that they
correspond with the mounting points on the rails.
2 Extend both of the rails so that they are the right length to fit in your rack.
3 Bolt the rails into the rack using the rack bolts supplied with your rack.
You will need four nuts and bolts (not included) for each rail; two at the front
and two at the back.
4 Tighten the locking screws when they are the correct length.
5 Slide the system into the rack and bolt it into place with the supplied fixing
screws.
Caution
This product is heavy. Attempting to install the system in a rack by your-
self could result in injury or damage to the product.