MaxPro PROFESSIONAL MPPO1200, Manual

Page: 10 / 39

7 GB
accessory runs freely by turning it by hand - test-run tool for at least 30 seconds at highest no-load speed
in a safe pos - stop immediately in case of considerable vibra or other defects and check tool to
determine the cause
4.On/ off
- switch on/o ff the tool by pulling/releasing trigger H
5.Electr
-start Ensures reaching the maximum speed smoothly without a sudden impact when tool is switched on
6.Swit ch locking f or con
- pull trigger
- press knob J with your thumb
- unlock the switch by pulling again trigger H and then releasing it
7.Speed contr ol
- with wheel K the maximum speed can be adjusted from low to high (1-MAX)
- st wer speed)
- if needed, select a higher speed while the tool runs
- the op working speed depends on the material and can be determined with pr cal trials
8.Opera t ool
- switch on the tool - place the tool fully on the surface to be polished and move it evenly by - one
move should overlap the previous move by one half
- do not stop at a single spot to avoid burning the coa
- do not move the tool in circles to avoid staining or burning the coa ! before switching o ff the tool, you
should it from the workpiece ! the accessory con to rotate for a short a er the tool has been
switched o ff
9.Holding and guiding the t ool
while working, always hold the tool at the area(s)
- always hold the t ool firmly with both hands, so you will have full control of the tool a
- provide for a secure stance ! do not apply so much pressure on the tool that it comes to a stands
- keep ven a covered
CLE ANING AND MAINTENANCE
Protect the tool from impact, shock and grease Always keep tool and cord clean (especially ven la on slots)
disconnect the plug before cleaning
do not a empt to clean ven a b nted objects through openings
ENVIR ONMENT
• Do not dispose of electric tools, accessories and packaging together with household waste material -
in observance of European Direc ve 2002/96/EC on waste of electric and electronic equipment and its
implementa in accordance with na law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compa recycling facility.