4
GB
(contact with or inhala
of the dust may cause allergic rea
s and or respiratory diseases to the
operator or bystander
wear a dust mask and work with a dust extr
evice when connectable
Certain kinds of dust are
as carcinogenic (such as oak and beech dust) especially in c
with
ves for wood c
wear a dust mask and work with a dust extr
device when
connectable
Follow the dust-related na
requirements for the materials you want to work with
Wear prot
ve gloves, safety glasses, close-
rot
for long hair)
Secure the workpiece
(a workpiece clamped with clamping devices or in a vice is held more securely than
by hand)
When sanding metal, sparks are generat
do not use dustbox and keep other persons and combus
material from work area
DURING USE
ways keep the cord away from moving parts of the t
rect the cord to the rear, away from the tool
touch the moving sanding disc
case of electrical or mechanic
ately switch o
tool and disconnect the plug
If the cord is damaged or cut through while working, do not touch the cord, but immediately disconnect
the plug
AFTER USE
When you put away the tool, switch o the motor and ensure that all moving parts have come to a
complete stands
CONNECTING NEW 3-PIN PLUG (U.K. ONLY):
Do not connect the blue (= neutral) or brown (= live) wire in the cord of this tool to the earth terminal of
the plug
If for any reason the old plug is cut o the cord of this tool, it must be disposed of safely and not le
una ended
OPERATING INSTRUCTION
Speed Controller
With the speed controller (3) you can adjust the speed according to applica
ropriate
speed se
ke sure the sander does not become overloaded and stops running.
Turn the speed controller (3) steplessly to the desired se
to increase or decrease the speed. The
controller can be adjusted from 1-6. The speed rate can be changed during opera
well.
Hint: The required speed rate for cu
resp,sanding a workpiece depends on the material that you are
going to process. For best performance, make some pr
cal tests.
Always use abrasive papers suited to the material you want to sand. Then papers must have correct grain
size.
Depending on grain size there are degrees of coarseness. The coar
by a number on the
back of paper
rain.
(Fig.3)
Read the manual
Warning
Wear dusk mask
Do not dispose of old appliances in the
household garbage
Disconnect from power supply while
maintance
SYMBOLS
