MAXIMUM
®
Air-powered Right
13
12
WARNING!
Potential hazard that could result in serious injury or
loss of life.
Description
No.
1
2
3
4
No.
5
6
7
Filter
Cut-off valve
Air compressor
Air system
• Always use clean, dry, regulated, compressed air at the recommended
pressure (see section “Technical Specifications”).
1
2
3
5
4
6
7
Lubricator
Regulator 0-123 PSI (0 -8.5 bar)
Description
•
•
•
•
•
•
Maintain the air pressure at 90 PSI and air flow according to the
recommended specifications. Do not exceed the maximum or minimum
pressures. Operating the tool at inappropriate pressure (too low or too
high) will cause excessive noise or rapid wear of tool.
Increase line pressure to compensate for unusually long air hoses. The
minimum hose diameter must be 1/4" ID and the fittings used must have
same dimensions.
Ensure that air valve is in “off” position before connection to the air
supply.
Clean the filter and the air inlet on a weekly basis.
Clean the compressor tank daily as water in the air supply line can
damage the angle die grinder.
Verify that all connections in the air supply system are sealed in order to
prevent air leakage.
AIR TOOLS
Read this Instruction Manual carefully before using the tool.
• Read and follow all the safety instructions at the beginning of this manual.
Inspect the Air-powered Right Angle Die Grinder prior to each use in
order to:
– Ensure that the proper power source is being used.
– Verify that the tool is in proper working order.
• Do not use the tool if it is not in proper working order.
• Do not use oxygen, CO2 (carbon dioxide), or any other combustible or
bottled gas to power this tool.
• Do not use this tool in the presence of any flammable liquids or gases.
Failure to comply could result in serious injury or loss of life.
Angle Die Grinder
Air hose
model no. 058-9367-8 | contact us 1-888-670-6682
TM
