34
QM01001-1
1.
Press the
STANDBY/ON
button on the projector or the remote control.
The message “Power off?” will appear on the screen for about 5 seconds.
Turning off the power
2.
Press the
STANDBY/ON
button again while the message appears.
The light source will go off, and the
POWER/STATUS1
indicator will begin
blinking in orange. Then the
POWER/STATUS1
indicator will stop blinking
and light in steady orange when the light source cooling is completed (
91
).
3.
Attach the lens cover, after the
POWER/STATUS1
indicator turns to steady
orange.
Power on/off
►Do not touch around the exhaust vents during use or just after
use, since it is too hot.
►Unplug the projector from the power outlet if the projector is not being used.
Remove the power cord for complete separation.
WARNING
• Turn off the projector by following the correct procedure. Power off the
projector after any connected devices are powered off. Do not turn on or off the
projector while connected to a device in operation, unless that is directed in the
manual of the device. If the projector is not turned off by following the correct
procedure, it may shorten its service life due to not being cooled down normally.
Turn off the projector by following the correct procedure (
above
) except in
emergency.
• If the projector is not turned off by following the correct procedure due to
power outage, unplug the power cord and leave the projector to cool down
sufficiently.
• This projector has the function that can make the projector automatically turn
on/off. Please refer to the DIRECT POWER ON (
71
), AUTO POWER ON
(
71
) and AUTO POWER OFF (
72
) items of the OPTION menu.
NOTE
