MATTHIESEN Magic Finger Bagger, Owner'S Manual

Page: 32 / 85

Troubleshooting Chart
Symptom Possible Causes(s) Corrective Action
Unit fails to operate 1. Blown fuse or open circuit breaker 1. Replace fuse or reset circuit breaker
2. No power
2. Contact power company
3. Defective motor 3. Repair or replace
4. Excessive load 4. Reduce load
Motor runs but no output 1. No input key 1. Install key (see installation)
2. Defective gear(s) 2. Check and replace if necessary
Intermittent rotation of output shaft 1. Poor electrical connection 1. Check connection
2. Damaged gear assembly possibly 2. Replace gear and if possible, avoid shock
caused by shock load load
Excessive noise 1. Bearings worn 1. Replace
2. Belt too tight 2. Adjust tension
3. Overhung Load - exceeds rating 3. Correct load and/or replace bearing
and causes bearing wear
4. Insufficient lubrication 4. Check oil level
Oil leak 1. Vent plug not installed 1. Install vent plug
2. Gasket broken or not seated 2. Replace or reseat gasket
3. Damaged or worn seal 3. Replace seal
4. Too much oil 4. Check oil level
Dayton Operating Instructions and Parts Manual
®
7
Models 2Z932F thru 2Z935F
32