MATTHIESEN Magic Finger Bagger, Owner'S Manual

Page: 18 / 85

Dayton Speed Reducers
Operating Instructions & Parts Manual
2Z306F thru 2Z310F
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described.
Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or
property damage! Retain instructions for future reference.
Form 5S4807
®
®
Printed in U.S.A.
02263
1102/254/VCPVP
Description
Dayton right-angle speed reducers are designed for continuous duty, high torque,
slow speed applications such as packaging, food processing, etc. Units are
equipped with hardened worm and bronze worm gear, Timken roller bearings on
output shaft, double lip seals and cast aluminum housing.
NOTE: Speed reducers are built for direct coupling or V-belt drive with up to a 1
HP, 1725 RPM motor. Lower input speed may be used with a proportional
decrease in input HP and output speed. Lower input HP may be used with a
proportional reduction output torque. (Consult Specifications)
Figure 1
Dimensions
A C D D
1
E F H N N
1
5 ¾
7 1/16
2 ½ 4 ½
2 3/8 4 ¾ 1 1/32 1 13/32
2
O U U
1
V V
1
AB XL
5 13/16
0.7500/0.7495 0.6250/0.6245
1 5/8 1 7/16 2 7/16
8
NOTE: All dimensions given in inches.
General Safety Information
The safety information following refers
to the complete installation as well as
the reducer.
Disconnect
power before
installing or servicing.
1. Follow all local electrical and safety
codes, the United States National
Electrical Code (NEC) and the
Occupational Safety and Health Act
(OSHA).
2. Motor (not included with this unit)
must be securely and adequately
grounded. This can be accomplished
by wiring with a grounded, metal-
clad raceway system, by using a
separate ground wire connected to
the bare metal of the motor frame,
or other suitable means. Refer to
NEC Article 250 Grounding for
additional information
3. Always disconnect power source
before working on or near a motor
or its connected load. If the power
disconnect point is out of sight, lock
it in the open position and tag it to
prevent unexpected application of
power.
4. All moving parts should be guarded.
5. Be careful when touching the
exterior of an operating motor; it
may be hot enough to be painful or
cause injury. Modern-design motors
run hot when operated at rated
load and voltage.
6. Prevent the power cable from
touching sharp objects, oil, grease,
hot surfaces, or chemicals
7. Do not kink the power cable.
8. Make certain that the power source
conforms to the requirements of
your equipment.
9. Keep cleaning rags and other
flammable waste materials in a
tightly closed metal container and
dispose of in the proper fashion.
10.Clean electrical or electronic
equipment with approved cleaning
agent such as dry cleaning solvent.
11.Be sure the output shaft key is fully
captive or is removed before
running the reducer.
Do not install
an automatic
reset motor starting device in
applications where unexpected
starting could harm personnel or
equipment.
!
WARNING
!
CAUTION
Figure 2
18