66
9.14 ConSolE mAST ARm REPlACEmEnT
ChapTEr 9: parT rEplaCEmENT GUidE
1) Turn off power to the unit and disconnect the cord from the machine.
2) Remove the console as outlined in Section 9.13.
3) Take off the cup holder from the right side of the treadmill (Figure A).
4) Use a 6 mm Allen wrench to remove one screw and take off plastic hand rail (Figure B).
5) Remove the 5 Phillips screws and remove the right side upper plastic cover (Figures C, D, & E).
6) Cut the wire ties and begin to unthread the console cable (Figures F & G).
7) Remove the screws holding the console frame to the mast arms with a 6 mm Allen wrench in the openings with arrows (Figure H).
8) Lift the frame from the mast arms and set it aside (Figure I).
9) Use a 6 mm Allen wrench to remove the lower mast arm mounting screws (Figure j).
10)Pullthemastarmfromthesideofthemachine(FigureK).
11) If replacing the right side mast arm, the console cable must be threaded through it.
12) Auto Calibration must ALWAYS be run after replacing the console masts (see Section 3.5).
fiGuRE A
fiGuRE b
fiGuRE C
fiGuRE d
fiGuRE E
Summary of Contents for T7XE-01
