Matrix SIMADO GFXD1111S, System Manual

Page: 129 / 194

Matrix SIMADO GFXD1111S V3 System Manual 123
By default, Transmit Gain is 3.
Use following command to default the transmit gain of the Mobile Port:
272-0-#*
Pause Timer:
Pause timer is the time for which GFXD1111S will wait while dialing out DTMF digits on the Mobile Port when
character P is detected in the DTMF number string.
Use following command to program Pause Timer for Mobile Port:
275-Pause Timer-#*
Where,
Pause Timer is from 1 to 9 seconds.
By default, Pause Timer is 2 seconds for Mobile Port.
Example: If number string to be dialed out on the mobile port is PPP234 and pause timer is programmed as 3
seconds then GFXD1111S will dial out digit 2 after P+P+P seconds i.e. 3+3+3=9 seconds.
DTMF Dialing Method:
DTMF Dialing Method is required during Multi-Stage Dialing. GSM/CDMA module supports DTMF dialing either
using 'Module Resources' or 'System Resources'. SE is recommended to select the suitable method.
• Using Module Resources: In this method, the DTMF digits are dialed using AT commands. But this
method depends on the network i.e. for how much time the DTMF tone should be generated depends
upon the service provider. However, in some cases where DTMF On time is required for more detection at
the remote end, it cannot be set by the module.
• Using System Resources: In this method, the DTMF digits are dialed by specific hardware device of the
system and is controlled by the software of the system. However, this method is also not so reliable
because it depends upon the network conditions and during call through mobile network, generally there is
break in the speech and it may not be detected properly at the remote end.
Use following command to program 'DTMF Dialing Method' for the Mobile Port:
273-Code-#*
Where,
By default, it is set to 'Using Module Resources'.
Baud Rate (SMS + In FAX + Data):
(Refer “Mode of Operation” for details)
Relevant Topics:
1.
“Automatic Number Translation” 23
2.
“Location Information Indication” 84
3.
“Multi-Stage Dialing” 94
4.
“Mobile Network Selection” 86
5.
“Port Parameters-FXS” 116
6.
“SMS (Short Message Service)” 147
Code Meaning
1 Using Module Resources
2 Using System Resources