Matrix SIMADO GFXD1111S, System Manual

Page: 29 / 194

Matrix SIMADO GFXD1111S V3 System Manual 23
Automatic Number Translation
Automatic Number Translation feature translates the number dialed by the user to the number that is understood by
the PSTN or GSM/CDMA network. SE can program ANT table for both FXO and Mobile Port.
Let us take an example to understand this feature:
Suppose user dials 952668263172 from the telephone instrument connected to the FXS port of the system since
he is habituated to dial numbers in this way on the POTS network. SIMADO GFXD1111S routes this call through
GSM/CDMA port to the desired destination depending on the programming done. But GSM/CDMA network does
not understand the dialed number string. Instead it expects the user to dial +912668263712. Automatic Number
Translation feature does this.
To accomplish this, SE should program 95 in dialed number string and +91 in the substitute number list. Doing so,
whenever the user dials number string starting with digits 95, ANT will translate it to +91 and then will route the call
to the desired destination number.
GFXD1111S also supports multi-stage dialing through its Mobile/FXO Port. (Refer “Multi-Stage Dialing” for more
details)
Default Automatic Number Translation Table is as shown below:
How to Program?
Automatic Number Translation table consists of following columns:
1.
Index: This is the number at which entry is done. Total 32 entries can be made in the Automatic Number
Translation table from 1 to 32.
2.
Dialed Number String: Program the numbers that user can dial out from SIMADO GFXD1111S in this
column.
3.
Substitute Number String: Program the numbers that the system should dial out in place of the dialed
number string in this column.
Use following command to program the Dialed Number String for the Mobile Port:
291-Number Index-Dialed Number String-#*
Where,
Number Index is from 01 to 32.
Dialed Number String can be of maximum 16 characters.
Allowed characters are 0-9, #, *, A, B, C, D, F, P,W and +, where, A, B, C, D are DTMF digits, F stands for Flash, P
stands for Pause and W stands for Wait.
By default, dialed number string is blank for all entries.
Index Dialed Number String Substitute Number String
1 Blank Blank
2 Blank Blank
3 Blank Blank
: : :
: : :
32 Blank Blank