Matrix r7xi-02, Service Manual

Page: 120 / 166

117
9.26 TESTiNg THE BiKE
oNCE THE UNiT or rEPlACEMENT PArT iS fUlly iNSTAllED AND ASSEMBlED AND
ProPErly PlACED oN THE floor, USE THE folloWiNg iNSTrUCTioNS To SETUP
AND TEST THE MACHiNE:
1) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER) and input the serial number of the console and frame. Also set the Machine Type (ENTER,
3, 0, 0, 2, ENTER) and verify that the Date and Time are correct (See Section 7.2). note: If he Machine Type setting has been changed, the
unit power should be reset. Cycle the power switch.
2) Enter Service Mode (ENTER, 3, 0, 0, 1, ENTER). Then edit Club ID on the Asset Management and Root Path on the Virtual Active
depending on whether the club has these functions.
3) Program the TV channels as outlined in Section 10.6.
4) Without hitting start or entering any program modes, sit on the bike and hold the handlebars while pedaling to simulate exercising. While
moving, listen for any odd noises or squeaks.
5) After stopping movement, press the green GO key and begin pedaling.
6) Grasp the hand grips to check for proper heart rate response.
7) Press the level up and down buttons on the console and hand grips to make sure resistance is fully functional.
8) If everything functions properly, stop pedaling and the unit will reset to normal operation within 30 seconds.
CHAPTEr 9: PArT rEPlACEMENT gUiDE