Matrix E3XE - 01, Service Manual

Page: 82 / 91

79
10.5 TV BRACKET INSTALLATION
The Matrix E3xe-01 Suspension Elliptical is capable of accepting a 15" TV via a bracket. Follow the
instructions below to install the TV and bracket. Use the instructions in the Entertainment Owner's Manual
to program the TV after installation.
1) Turn off power and disconnect the power cord.
2) Remove the console from the Suspension Elliptical.
3) Remove the 2 screws holding the small silver back cover to the console and remove the back cover (Figures A & B).
4) Remove the 4 screws holding the rear half of the console to the front half and split the console (Figures C & D).
5) Plug the TV power wire into the UCB (Figure E).
6) Plug the TV controller wire into the UCB (Figure F).
FIGURE B FIGURE A
FIGURE D FIGURE C
FIGURE F FIGURE E
CHAPTER 10: SUSPENSION ELLIPTICAL SPECIFICATION AND ASSEMBLY GUIDE