77
76
10.4 STAbIlIZINg THE ClIMb MIll
STABILIZING THE MATRIX C5X-04 CLIMB MILL
The Matrix Climb Mill should be level for optimum use. Locate a level, stable surface to position the equipment. The equipment has leveling
transport wheels located under the "Control Zone" cover (Figure A). To access, grab the left and right sides of the cover and lift off.
CAUTION:
There is an electrical plug located under the cover that will need to be unplugged before the cover can be completely removed. With the
"Control Zone" cover removed, adjust the transport wheels until the equipment is stable and lock the wheels into place. Once stable, plug the
electrical connection back together and place the "Control Zone" cover back into place.
fIgURE A
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE
10.5 MyE TV bRACkET INSTAllATIoN INSTRUCTIoNS
CHAPTER 10: ClIMb MIll SPECIfICATIoNS ANd ASSEMbly gUIdE
The Matrix Climb Mill is capable of having a MYE Entertainment or Web Ready (PCTV) television installed using an integrated bracket. Follow
the instructions below to install the MYE TV and TV bracket, and the instructions located in the TV owner's manual to program the television.
1) Turn off power, and remove the cord from the machine.
2) Remove the console from the unit as outlined in Section 9.2.
3) Remove the 6 screws holding the console front to the back and split the console (Figures A & B).
4) Remove the 2 screws holding on the blank headphone jack plastic to the console, and remove the plastic (Figures C & D).
5) Remove the wire in the console that goes from the UCB to the board on the console back (Figure E).
6) Install the new Y cable sent with the TV bracket kit to replace the wire removed in Step 4 (Figure F).
fIgURE A
fIgURE b
fIgURE C
fIgURE d
fIgURE E
fIgURE f