69
68
CHAPTER 9: PART REPlACEMENT gUIdE
9.20 IR SENSoR REPlACEMENT - CoNTINUEd
8) Remove the IR sensor with plate from frame (Figure E).
9) Remove the 2 screws holding the IR sensor to the plate (Figure F) and remover the IR sensor.
10) Reverse Steps 1-9 to install a new IR sensor.
NOTE:
When re-installing the IR sensor, make sure that the IR sensor with gray wire on the left
(transmission) and another IR sensor with black wire on the right (receiver).
11) Once the IR sensor is installed, Press the green GO key and begin using the machine. Put your foot in the middle of the IR sensors
(transmission & receiver) to test the sensors are working and enough to stop machine (Figure G).
NOTE:
The sensor has an eye. The eye of two
sensors should be mounted opposite enough to fully functional (Figure H)
. Remove the Control Zone first before you start the IR sensor tests.
12) Test the Climb Mill for function as outlined in Section 9.21.
fIgURE E
fIgURE f
fIgURE g
fIgURE H
9.21 TESTINg THE ClIMb MIll
oNCE THE UNIT oR REPlACEMENT PART IS fUlly INSTAllEd ANd ASSEMblEd ANd
PRoPERly PlACEd oN THE flooR, USE THE followINg INSTRUCTIoNS To TEST
THE MACHINE:
1) Enter Engineering Mode (LEVEL UP and DOWN for 3 seconds) and input the serial number of the console. Also set the Machine Type and
enter Service Mode to verify that the Date and Time are correct.
2) Press the green GO key and begin using the machine. Stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
3) Grasp the hand grips to check for proper heart rate response.
4) Press the LEVEL UP and DOWN keys on the console to make sure resistance is fully functional.
5) Try stepping off the unit to make sure the proximity sensor is fully functional. Also test the STOP key on the grips, IR sensor and the Control
Zone for function. .
CHAPTER 9: PART REPlACEMENT gUIdE
