59
58
9.12 bRAkE REPlACEMENT
1) Turn off the power and disconnect the cord from the machine.
2) Remove the Matrix logo covers from each side of the machine.
3) Turn the brake lever to the right to lock the stairs and prevent movement that could cause injury.
4) Disconnect the brake and both fan wire connections (Figure A).
5) Remove the 4 screws holding the brake and fan plate to the drive set (Figure B) and remove the assembly.
NoTE: bEfoRE REMoVINg
THE bRAkE ANd fAN PlATE, bloCk THE STAIRS fRoM RoTATINg (place a block under the bottom stair) To PREVENT INJURy.
6) Remove the 3 screws and 2 cable ties holding the brake and brake wire to the plate (Figure C).
7) Reverse Steps 1-6 to install a new brake.
NOTE:
When re-installing the plate assembly, make sure that the hexagon shaped plate on the
brake lines up with the slots in the shaft of the flywheel (Figure D).
8) Test the Climb Mill for function as outlined in Section 9.21.
fIgURE A
fIgURE C
fIgURE d
CHAPTER 9: PART REPlACEMENT gUIdE
fIgURE b
9.13 fAN REPlACEMENT
CHAPTER 9: PART REPlACEMENT gUIdE
fIgURE A
fIgURE b
fIgURE d
fIgURE C
1) Turn off the power and disconnect the cord from the machine.
2) Remove the Matrix logo covers from each side of the machine.
3) Turn the brake lever to the right to lock the stairs and prevent movement that could cause injury.
4) Disconnect the brake and both fan wire connections (Figure A).
5) Remove the 4 screws holding the brake and fan plate to the drive set (Figure B) and remove the assembly.
NoTE: bEfoRE REMoVINg
THE bRAkE ANd fAN PlATE, bloCk THE STAIRS fRoM RoTATINg (place a block under the bottom stair) To PREVENT INJURy.
6) Remove the 4 screws and 2 cable ties holding the fan and fan wire to the plate (Figure C).
7) Reverse Steps 1-6 to install a new fan.
NOTE:
When re-installing the plate assembly, make sure that the hexagon shaped plate on the brake
lines up with the slots in the shaft of the flywheel (Figure D).
8) Test the Climb Mill for function as outlined in Section 9.21.