Matrix C5X-05, Service Manual, Page: 26 / 48

47 46
9.4 fRoNT SHRoUd REPlACEMENT - CoNTINUEd
CHAPTER 9: PART REPlACEMENT gUIdE
8) Disconnect the hand pulse and quick key cables on the inside of the console mast (Figure E).
9) Remove the 8 screws holding the lower handlebar set to the console mast (Figure F).
10) Remove the 4 screws that attach the console mast to the frame (Figure G).
11) Pull the cables out of the console mast and remove it (Figure H).
12) Remove the 4 screws holding the front shroud to the sides (Figure I).
13) Pull up on the front shroud and remove it (Figure J).
14) Reverse Steps 1-13 to install a new front shroud.
15) Test the Climb Mill for function as outlined in Section 9.21.
fIgURE E fIgURE f
fIgURE H fIgURE g
fIgURE J fIgURE I
CHAPTER 9: PART REPlACEMENT gUIdE
9.5 lowER CoNTRol boARd (lCb) REPlACEMENT
1) Turn off power and disconnect the cord from the machine.
2) Remove all wiring from the front cover and remove it from the machine as outlined in Section 9.4.
3) Disconnect all wiring from the LCB (Figure A).
4) Remove the 2 screws holding the LCB to the frame and remove the LCB (Figure B).
5) Remove the 2 screws that hold the fan to the LCB and remove it (Figure C).
6) Reverse Steps 1-5 to install a new LCB.
7) Test the Climb Mill for function as outlined in Section 9.21.
fIgURE A fIgURE b
fIgURE C