Matrix Fitness T1X-03AC, Service Manual

Page: 47 / 76

44
9.8 MOTOR CONTROL BOARD (MCB) REPLACEMENT
1) Turn off power and disconnect the cord from the machine.
2) Remove the motor cover as outlined in Section 9.1.
3) Disconnect the wire connectors at the MCB.
4) Remove the 2 screws holding each side of the MCB to the frame (Figures A & B).
5) Remove the MCB (Figure C).
6) Reverse Steps 1-5 to install a new MCB. Make sure that all wires removed during Step 3 are re-connected.
NOTE:
There will be an 8 pin
connector coming from the console mast that will not be used for this model (Figure D).
7) Test the treadmill for function as outlined in Section 9.21.
FIGURE A FIGURE B
FIGURE C
FIGURE D
CHAPTER 9: PART REPLACEMENT GUIDE