Maintenance
Page 42
Danger!
The operator and other persons can be severely injured.
Only perform service and maintenance tasks with lifted bin if the bin has
been safeguarded against falling unintentionally by appropriately position-
ing the lowering safeguard.
To adjust how tightly the cover the of the collecting tank seals, you can
adjust the longitudinal and transverse alignment of the hinges and
adjust the length of the cylinder rod.
Proceed as follows to adjust the hinges:
1.
Ensure that the collection bin is empty.
2.
With ignition switched off, activate the tractor's hydraulic system to offload the cover
cylinder.
3.
Loosen the mounting screws of the hinges (see Fig. 67):
-
Loosen the rear screws to adjust the alignment of the cover in the longitudinal di-
rection.
-
Loosen the front screws to adjust the alignment of the cover in the transverse di-
rection.
Fig. 67: Cover hinges
4.
Re-align the cover accordingly.
5.
Re-tighten the mounting screws of the hinges.
6.
Check whether the cover seals tightly.
If necessary repeat steps 1 to 5.
Proceed as follows to adjust the length of the cylinder rod:
7.
Open the bin cover
8.
Secure the cover against unintended closing with suitable props.
If you have a high-dump CLS-G/H 650/8500 you can lift the bin for the adjustment
work.
Comply with the following instructions in this regard:
-
Hook in the lowering safeguard after you have lifted the bin and do not forget to
unhook the lowering safeguard before lowering the bin.
-
Before lifting or lowering the bin you must close the cover.
Adjustment in the
longitudinal
direction
Adjustment in the
transverse direction