Attaching and detaching the CLS 650/850
Page 21
3.
Place the lower link of the rear three-point linkage on the lower link bolt on the CLS.
4.
Secure the connection with the linch pins.
5.
Adjust the desired length of the upper link.
To adjust the length of the upper link, turn the threaded sleeve while holding the
threaded spindle.
6.
Fasten the upper link to the CLS with the upper link bolt (see Fig. 26).
Fig. 26: Upper link on the CS
7.
Secure the connection with the linch pin.
8.
Couple the PTO shaft to the tractor. To do this proceed as described in section
5.2.2.
9.
Slide the suction hose onto the opening on the turbine cover and secure the connec-
tion with the hose clamp (see Fig. 27).
If you have removed the suction hose from the suction connector on the mower
since last using the CLS, then slide the suction hose over the suction connector
again and secure the connection with the hose clamp.
Fig. 27: Suction hose on the turbine cover
10. Connect the hydraulic connections of the CLS to the connections on the tractor.
11. Connect the plug-type connector to the tractor's 12 V power connection.
Hose clamp
Upper link bolt
