matev CLS-G 650 SE, Operating Manual

Page: 27 / 51

Attaching and detaching the CLS 650/850
Page 27
4. Unplug the plug-type connector from the tractor's power connection.
5. Uncouple the PTO shaft on the tractor.
To do this proceed as described in section 5.2.3.
6. Disconnect the suction hose from the connector on the CS by loosening the hose
clamp (see Fig. 41).
Fig. 41: Suction hose on the turbine cover
7. Disconnect the connection of the upper link on the CLS.
8. Take the lower link arms of the rear three-point linkage off of the CLS, and push the
CLS back a short distance.
9. Drive the tractor forward, away from the CLS.
6.4 Attachment with quick-hitch

Danger!
If you do not comply with the following instructions the implement can tip
over when it is being attached:

Ensure that the CLS is on a level and solid substrate.

Only mount the CLS if the collection bin is empty, closed and lowered.
 Note!
You can only attach the CLS to a tractor with quick-hitch if you have se-
lected the CLS with chassis.
The position numbers used in the attachment instructions below refer to the number of the
components in
Fig. 2 in section 5.1.1.
Proceed as follows to attach the CLS to a quick-hitch:
1. Turn the pivot wheels to the rear and secure them with the tube linch pins (see Fig.
42).
Hose clamp