Page | - 2 -
© Copyright Mastip Technology Limited. Information subject to alteration. V3.51a www.mastip.com
Temperature Controller
METICOM TM10 Module
WARRANTY
We warrant that this product will be free from defects in materials and workmanship for a period of two (2)
years from the date of shipment. If any such product proves defective during this warranty period, we, at
our option, either will repair the defective product without charge for parts and labor or will provide a
replacement in exchange for the defective product.
This warranty shall not apply to any defect, failure or damage caused by improper use or improper or
inadequate maintenance and care. We shall not be obligated to furnish service under this warranty; a) to
repair damage resulting from attempts by personnel other than our representatives to repair or service the
product; b) to repair damage resulting from improper use or connection to incompatible equipment; or c) to
service a product that has been modified or integrated with other products when the effect of such
modification or integration increases the time or difficulty of servicing the product.
This warranty excludes replacement of fuses, triac, calibration, contact points and damage to the
module from the use of improper styles of fuses. The maximum allowable fuse rating is 15 amps. Lower
ratings may be used for improved protection.
SAFETY
Our products have been designed to be safe and simple to operate. As with any electronic equipment, you
must observe standard safety procedures to protect both yourself and the equipment.
Cautions:
Service and installation of this equipment should only be performed by qualified service personnel
familiar with high voltage electrical circuits.
All international and local electrical codes must be followed when connecting this equipment.
Only persons with knowledge of the system's operation and capabilities should operate the system.
Read all of these instructions before connecting power and turning on the system.
Unless specifically explained in this manual or directed by us, do not attempt to repair the system
yourself. Doing so could result in damage to the system, or serious personal injury.
To Prevent Injuries:
Do not apply voltage to a terminal that exceeds the range specified for that terminal.
Do not operate this product with covers or panels removed. All unused slots of a main frame must be
covered with the appropriately sized blank panels.
Do not operate this product when wet.
Do not operate this product in an explosive atmosphere.
To Prevent Product Damage:
Do not operate this product from a power source that applies more than the voltages specified.
Do not connect thermocouples to any live areas of the heaters. Lock out and tag the controller and mold
and make sure there is electrical insulation between the thermocouple and any live areas.
After turning on the system, you should make sure that fans are running.
Never allow the fan outlets on the unit become blocked, this is where the system's cooling airflow exits.
If this area of the mainframe becomes cluttered and insufficient airflow or the system maybe damaged.
