EN / Mass Sine Ultra
6
2 SAFETY GUIDELINES AND
WARNINGS
2.1
Warnings and symbols
Safety instructions and warnings are marked in this manual
and on the product by the following pictograms:
A procedure, circumstance, etc. which deserves
extra attention.
CAUTION!
Special information, commands and prohibitions
in order to prevent damage.
WARNING
A WARNING refers to possible injury to the user
or installer or significant material damage to the
Mass Sine Ultra if the installer / user does not
(carefully) follow the stated procedures.
Read this manual before installation and use.
This product has been declared conform the EC
directives and standards.
Degree of protection: IP23. The product is
protected against touch by fingers and water
spray < 60 degrees from vertical.
Safety class 1. This product must be provided
with an equipment grounding conductor to the
AC-output ground terminal.
2.2
Use for intended purpose
1
The Mass Sine Ultra is constructed as per the
applicable safety-technical guidelines.
2
Use the Mass Sine Ultra only:
•
for the conversion of battery DC voltage to AC
voltage;
•
with a fuse, protecting the wiring between Mass
Sine Ultra and battery;
•
in a technically correct condition;
•
in a closed, well-ventilated room, protected against
rain, moist, dust and condensation;
•
observing the instructions in the user’s manual.
WARNING
Never use the Mass Sine Ultra in situations where
there is danger of gas or dust explosion or
potentially flammable products!
3
Use of the Mass Sine Ultra other than mentioned in
point 2 is considered to be inconsistent with the
intended purpose. Mastervolt does not hold itself liable
for any damage resulting from the above.
2.3
Organizational measures
The user must always:
•
have access to the user’s manual;
•
be familiar with the contents of this manual. This applies
in particular to chapter 2, Safety Guidelines and
Warnings.
2.4
Warning of special dangers
1
If the Mass Sine Ultra is switched off during
maintenance and/or repair activities, it should be
secured against unexpected and unintentional
switching on:
•
remove the connection to the batteries
•
be sure that others cannot reverse the measures
taken.
2
If maintenance and repairs are required, use only
original spare parts.
2.5
General safety and installation precautions
•
Do not expose the Mass Sine Ultra to rain, snow, spray,
moisture, excessive pollution and condensing
circumstances. To reduce risk of fire hazard, do not
cover or obstruct the ventilation openings. Do not install
the Mass Sine Ultra in a non-ventilated area, overheating
results.
•
The Mass Sine Ultra must be provided with an
equipment grounding conductor to the AC-output ground
terminal. Grounding and all other wiring must comply
with local rules and regulations.
•
In case of fire, you must use a fire extinguisher which is
appropriate for electrical equipment.
•
Short circuiting or reversing polarity will lead to serious
damage to batteries, Mass Sine Ultra and wiring. Fuses
between batteries and Mass Sine Ultra cannot prevent
damage caused by reversed polarity and warranty will be
void.
•
Protect the DC wiring with a proper fuse, according to the
guidelines in this manual.
•
Connection and protection must be done in accordance
with local standards.
•
Do not work on the Mass Sine Ultra or system if it is still
connected to a power source. Only allow changes in your
electrical system to be carried out by qualified
electricians.