SAFETY GUIDELINES
9
MIG 140 INVERTER WELDER 058-9305-6
Note: Recycle the unwanted materials rather than disposing of them as waste. Sort the tools, hoses
and packaging in specific categories. Take them to the local recycling center or dispose of them in
an environmentally safe way.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
•
Do not operate the welder if the welding cables, electrode, MIG gun, wire or
wire feed system is wet. Do not immerse them in water. The welder and its
components must be completely dry before attempting to use the welder.
•
Keep the welder in the OFF position when not in use.
•
Do not wear watches, rings, bracelets, or loose clothing when using the
welder.
•
Maintain a correct position while using the welder. Mount the welder on a
secure bench or cart to prevent if from tipping over or falling.
•
Wear a full covered helmet with appropriate shade that conforms to
ANSI Z87.1 safety standard, proper gloves, and protective clothing such as
leather shirt, coat, pants, and insulated footwear to prevent the skin from
being exposed to hot metals, UV and IR rays while welding.
•
Do not overheat or overuse the welder to prevent it from being heated. Allow
proper cooling time between duty cycles. Always use this welder in the rated
duty cycle to prevent excessive heat and failure.
•
Ensure that all the components are clean and in good working condition before
use.
•
Do not use an extension cord, as it causes the voltage to drop and affects
the performance of the welder. If needed, use an extension cord having a
minimum size of 12 gauge and maximum length of 25 feet.
•
Use safety goggles and ear protection:
Wear safety glasses with side shields when operating the
welder and verify that others in the work area are also
wearing safety glasses. Safety glasses must conform to
American National Standards Institute (ANSI Z87.1)
requirements and must provide protection from flying
particles from the front and the sides.
Always wear ear protection to help prevent hearing damage.
Failure to comply may result in loss of hearing.
MC-OM-01
