ASSEMBL
Y INSTR
UCTIONS
21
MIG 140 INVERTER WELDER 058-9305-6
7. Turn ON the primary power switch (1) on
the back panel
(fig G)
. Refer to stick
welding operation pages 34
-
42.
Installation for MIG welding
Installing the wire roller
1. Open the wire drive compartment.
2. Remove the drive tension by loosening
the drive tension adjusting knob (1) and
lifting the drive tension adjustor and
drive tension arm (2) away from the
drive roll (3)
(fig H)
.
Note: Make sure the proper sized grooves of
the drive roll must be placed in the wire drive
compartment before installing the wire.
3. Insert the end of the wire into the hole (1)
on the outside edge of the wire spool and
bend the wire to hold it in place. Remove
the wire spool from the wire drive
compartment
(fig I).
Note: If the wire is already installed in the
welder, roll the wire back onto the wire spool
by manually rotating the wire spool clockwise.
Do not allow the wire to come out of rear end
of the inlet guide tube.
MC-589305-10
GAS INPUT
ENTRÊE DE GAZ
110V - 120V
1PH
OFF
ON
MARCHE
ARRÊT
POWER
PUISSANCE
fig G
1
MC-589305-11
3
1
2
fig H
1
MC-589305-12
fig I
