MasterCraft 2013 XStar, Owner'S Manual

Page: 360 / 466

Suntan Lotion, Grease, and Oils
Use an all-purpose cleaner or degreaser alone with a medium
bristled brush. Put small amount of the cleaner on the oil stain and
use a medium bristled brush and warm water to scrub until the oil
is out. Rinse with clean water and repeat if needed.
Rust Stains
Wet the affected area and apply a dry, powdered Oxalic acid (such
as Barkeeper’s Friend) to the rust stain. Use a medium bristled
brush to work the powder into the stain and allow to soak for 3-5
minutes. Rinse with water and repeat if necessary. When applying
oxalic acid, use care to avoid getting acid on the edges of the pad,
as it could damage the lamination or PSA.
Please follow your state and/or country regulations for proper
chemical handling.
Wear vinyl or nitrile gloves and eye protection when necessary.
USE WITH CARE
• Although highly effective, using a pressure washer to clean
SeaDek pads can cause damage if not done properly. DO NOT ex-
ceed 1200 PSI. Spray from the middle to the outside of the pads.
Do not point the pressurized spray under the edge of the pad.
• Acetone (if it must be used, avoid the edges of the pad to protect
the adhesive)
• Oxalic Acid (if it must be used, avoid the edges of the pad to pro-
tect the adhesive)
• Bleach (if used, dilute 1 cup with 1 gallon of water)
DO NOT USE
• Citrus Cleaners
• Mineral Spirits
For best cleaning results, tend to all stains, spills, and leaks as
soon as possible.
2021MCOwnerManualFINAL.indd 361 8/26/20 1:54 PM