MasterCraft 2013 XStar, Owner'S Manual

Page: 281 / 466

2021 OWNERS MANUAL /
280
Models
All models (excluding ProStar) have a bow cleat for securing anchor
lines. Anchors are optional on all models
Purpose
The anchor allows the boat to be temporarily moored in relatively
shallow water. Note that standard equipment does not include the
line for the anchor. This is because needs will vary considerably by
location of the body of water. The general rule of thumb is that the
boat owner should purchase anchor line from a marine aftermarket
company at a length about three-to-four (3-4) times the depth of
the body of water in which the boat will be moored.
Location
Some models are equipped with anchors, and there will be a
designated storage area or stowage location on the boat, normally
in the forward area of the bow. Check with your dealer if you are
uncertain about this area because it is important to keep the anchor
stowed when it is not in use. In some instances, ladders may also be
stowed in this location.
Operation
MasterCraft anchors are manually operated. The anchor has a
storage compartment at the front of the bow. After purchasing
Do not leave unattended, open food or other materials that could
melt, on a seat equipped with a seat heater that is or will be turned
ON. The additional heat could cause melting, resulting in a stain or
other damage that is not covered under warranty.
Troubleshooting
If the seat heat system does not work when the switch is ON, check
at the main circuit breaker panel to ensure the circuit has not tripped.
If so, reset. If the seat heater(s) still does not work or if the circuit
continues to trip, take the boat to an authorized MasterCraft dealer.
ANCHOR
2021MCOwnerManualFINAL.indd 280 8/26/20 1:53 PM