MasterCraft 2013 XStar, Owner'S Manual

Page: 285 / 466

2021 OWNERS MANUAL /
284
Purpose
The ZFT2, ZFT4 and ZFT7 biminis cast shade on the cockpit of the
boat to keep occupants cool and protected from the sun’s rays.
Location
Integrated into the ZFT2, ZFT4 and ZFT7 towers.
Operation
Biminis come pre-installed from dealers on all models.
To deploy the ZFT2, ZFT4 or ZFT7 Bimini:
For balance, it is suggested that operators have an additional
person assist when raising or lowering a bimini top.
1.
Unzip and remove the bimini boot cover.
2.
Unclip all clips securing the bimini legs to one another.
3.
Unfold and deploy the bimini. The bimini folds forward away from
the tower.
4.
Zip all of the zippers on the aft portion of the canvas around the
forward most tower tube.
5.
Buckle all straps around the tower loosely.
6.
Fully extend the bimini legs and ensure that they are locked into place.
7.
Tighten all straps and buckles around the tower so that the
canvas is stretched tightly around the tower.
Collapsing the bimini is the opposite of deploying it:
1.
Unlock the bimini legs and let them fold forward loosely.
2.
Loosen and unclip all buckles around the tower tubes and supports.
3.
Unzip all zippers around the tower tubes.
4.
Fold the bimini and canvas up to the tower.
5.
Use the gray leg clips to keep the bimini legs locked together.
6.
Cover the bimini with the protective boot and zip the boot around
the canvas.
Troubleshooting
Should the bimini ever bind or become locked in either the stowed
or deployed position, MasterCraft recommends that the bimini be
taken to an authorized MasterCraft dealer for repair. Improper use
may bend or deform the bimini frames, or may rip the bimini canvas.
Misuse is not covered under the warranty.
PROSTAR BIMINI
Models
ProStar
Purpose
The ProStar bimini casts shade on the cockpit of the boat to keep
occupants cool and protected from the sun’s rays.
2021MCOwnerManualFINAL.indd 284 8/26/20 1:53 PM