Mastercook KGE 3468ZB DYN, Instruction Manual

Page: 40 / 44

39
EN
Problem Solution
Gas burners fail to ignite Check to make sure the rubber hose supplying gas from the gas cylin - –
der is not squeezed.
Check to make sure the gas main valve is open. –
Check to make sure the gas cylinder is not empty. –
In case a new cooker has been installed or the gas cylinder has been –
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
Check to make sure the nozzle or burner flame holes are not clogged –
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo -
nents.
Flame dies after releasing the knob Your cooker is equipped with a flame failure safety device
Where the ignition device is built in the knob set the – knob to large fla -
me , press the knob and when the gas has ignited keep it pressed
all the way in for another few seconds. .
While igniting one of the burners all the
hob burner igniters spark
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
After setting the knob to simmering flame
position - the flame dies or is too high
Avoid draughts in the kitchen, –
Call the fitter to adjust simmering flame position – .
Flame is unstable
Check to make sure that the burner components are clean, dry and –
placed correctly.
Parts made of stainless steel (inox) deve -
lop stains that cannot be removed with the
use of standard cleaners
Stainless steel surfaces should be cleaned – each time they get soiled
and only with the use of special stainless steel cleaner.
Smoke coming out of the oven
Open the windows to air the kitchen, –
When the oven cools down, clean its interior. –
Use the drip tray when grilling foods. –