Master TOOL, User Manual, Page: 14 / 35

07
14. «PULL DOWN» FUNCTION
This function is available only if the motor has been programmed as «Awning with cassette». If the function is activated, after
closing the cassette the motor makes a brief downward movement to loosen the tension on the fabric. The factory sets this
parameter to the value 1 (Not active).
To change this parameter:
N° of movements Pull down
1
*
2
Not active
Active
*factory setting
R
MASTER uses packaging recyclable materials. Dispose materials on the proper containers, complying with the law in force in your locality.
This product may have substances that are polluting for the environment and dangerous for the health.
At the end of the product life cycle, carefully comply with the waste disposal rules. It is strictly forbidden to dispose the product on the domestic waste.
Disposal
All rights reserved. All products and technical specifications given in this document are subject to variation without notice. Unless previously and specifically authorised by the manufacturer, the device must be used
exclusively with transmitters produced by the same manufacturer. The manufacturer shall not be liable for damage resulting from improper, incorrect or unreasonable use.
Other transmitters...
See the User manual of
the transmitter at
section:
«RECEIVER MENU -
Function 24»
ARCO FLUTE, KUADRO, KORT VISIO
01. Bring the motor in an intermediate position
02. Press MENU for about 5 sec, until «rS»
appears on display
03. Press 2 times PREV and 4 times NEXT.
«24» appears on display
04. Press STOP. The motor signals the current
value (1 to 2 movements)
05. To deactivate: press PREV
To activate: press NEXT
06. Press STOP. The motor signals the new
value (1 to 2 movements)
01. Bring the motor in an intermediate position
02. Holding down STOP, press PROG for about
1 sec, until LEDs light
03. Press 2 times UP and 4 times DOWN.
04. Press STOP. The motor signals the current
value (1 to 2 movements)
05. To deactivate: press DOWN
To activate: press UP
06. Press STOP. The motor signals the new
value (1 to 2 movements)
01. Bring the motor in an intermediate position
02. Press MENU, «Menu rx» appears on
display
03. Press 2 times PREV and 4 times NEXT.
«24» appears on display
04. Press STOP. The motor signals the current
value (1 to 2 movements)
05. To deactivate: press DOWN
To activate: press UP
06. Press STOP. The motor signals the new
value (1 to 2 movements)