29
DO NOT DIVE.
104
DO NOT DIVE.
Regular Maintenance Procedures
Note: These are maintenance procedures are the responsibility of the swim spa owner to perform.
These procedures are not covered by the swim spa warranty.
Your swim spa requires periodic draining and cleaning to ensure a safe, healthy environment. It is
recommended that you clean your swim spa at least every 180 days. Heavy bather load will require
cleaning it more often.
DRAIN YOUR SWIM SPA
CLEAN YOUR SWIM SPA SURFACE
• With a soft cloth, wipe down the swim spa
surface with a non-abrasive swim spa surface
cleaner that may be purchased through your
local dealer. Do not use paper towels. Be sure
to rinse residue from swim spa surface.
• If your swim spa has developed an oily or
chalky residue at the waterline it may require
special treatment. Consult your dealer.
CLEAN THE ACRYLIC DIVIDER
(Momentum)
• The surface should be first flushed with clean
water to remove loose abrasive particles.
The clear acrylic sheet should then be gently
sponged with a mild detergent/water solution
and finally rinsed with clean water. Care must
be taken not to leave any of the soap residue
in the swim spa as it could cause the swim
spa water to foam during operation.
• Drying can be done with a clean soft cotton
towel. Avoid hard rough cloths or paper tow-
els since they can put fine scratches on the
acrylic surface.
• Do not use any aggressive solvents (lacquer
thinner, gasoline, acetone and etc.) on the
clear acrylic sheet. These products can cause
damage to the sheet that may not be visible
until days or weeks later.
• Window glass cleaning compounds are not
recommended. Cleaning products that con-
tain any type of abrasive material should not
be used.
REFILL YOUR SWIM SPA
• When filling the Momentum swim spa always
fill the swim side of the unit before filling the
spa side.
• Fill the swim spa with water and be sure that
water level is above the skimmer opening at
the minimum safe water level sticker.
• Refer to the start-up section for specific
instructions.
CLEAN YOUR FILTER ELEMENTS
• The filter elements are one of the most
important components of your swim spa.
Not only are they essential for clean water,
but they also extend the life of the swim spa
equipment. Your filter elements should be
cleaned on a regular basis, once a month
on average with normal usage. With heavy
use the filters may need to be cleaned more
often.
• Turn off the swim spa before servicing filters.
Never leave to the swim spa running when
removing the filters. Debris can be pulled into
the plumbing system and cause unwarranted
damage.
• With a garden hose, spray each element
under pressure. Periodically, the elements
need to be soaked in a filter cleaner com-
pound. Check with your dealer for details
on cleaning and/or filter replacement recom-
mendations. Do not soak the Eco Pur filter
cartridge in any cleaners.
• Replace filter elements.
• Be sure water level is adequate.
• Turn swim spa on.
CARE OF YOUR SWIM SPA PILLOWS
• Your swim spa pillows need to be rinsed peri-
odically to remove any chemical residue. This
should help to eliminate pillows becoming
stiff and discolored.
• If the swim spa will not be used for a period of
time, the pillows should be removed to extend
their useful life.
NOTE: Do not cover the swim spa for 15 minutes
after adding chemicals as the off gas can cause
damage.
MasterSpaParts.com
