3 |
P a g e
High Pressure Seal Cutter – User Manual
1.1.5.
If a 5/8” or 3/4" Tube Support is used, make sure the Tool Support labeled “FOR
5/8 AND 3/4 DIA” is installed. It is attached with two (2) 6-32 Socket Head Cap
Screws and Nylon Lock Nuts as shown in Figure 2.
Figure 1 – Tube Support Bracket
Figure 2 – Tool Support Bracket and Tool Mount
1.2.
Dremel Tool Attachment
1.2.1.
Clamp Dremel Tool to Tool Mount using four (4) 6-32 Socket Head Cap Screws
as shown in Figure 2.
1.2.2.
Install Fiber Cutting Wheel onto Rotary Mandrel.
1.2.3.
Attached Rotary Mandrel to Dremel Tool.
1.3.
Cutting Ferrules on a 5/8” or 3/4" Stub.
1.3.1.
Ensure proper attachments are installed for the diameter stub you are working on.
1.3.2.
Position ferrule between the upper and lower guide on the Tube Support Bracket.
1.3.3.
Once attached, tighten wing nut on the upper guide.
1.3.4.
Use the X & Y dials to move the Dremel Tool close to the ferrule.
1.3.5.
Turn on the Dremel Tool and use the X dial to feed the cutting blade into the
ferrule.
1.3.6.
Use the Y dial as needed to make a vertical cut in the ferrule.
6-32 Socket Head Cap Screw
QTY:4
6-32 Socket Head Cap Screw & Nylok Nut
QTY:2
6-32 Socket Head Cap Screw
QTY:4
Tube Support Bracket
(3/4” Shown)
