20
3.5.6.
Lokkonfiguration speichern
Speichen Sie hier die Konfiguration Ihrer
Lokomotive ab. Mit
M2
werden die Daten
permanent übernommen und sind beim
nächsten Einschalten der Zentrale auch noch
vorhanden. Speichern Sie die Daten dagegen
nur temporär mit
M3
, so sind die Daten dieser
Lokomotive nur während dieses Spielzyklu
-
ses vorhanden. Wird die Zentrale zu einem
späteren Zeitpunkt erneut eingeschaltet, sind
diese Daten nicht mehr vorhanden. Sind die
Daten der Lokomotive gespeichert, gelan
-
gen Sie direkt wieder in den Fahrmodus.
3.5.7. Lokadresse löschen
Durch langes Drücken der Taste
M2
gelangen
Sie in das Lok Konfigurationsmenü. Im ersten
Konfigurationsfenster haben Sie die Möglichkeit
eine nicht mehr benötigte Lok zu löschen. Durch
Drücken von
M1
wird die aktuelle Lok gelöscht.
Nun müssen Sie mit
M1
oder
M2
wieder eine
neue Lok auswählen und mit
M3
bestätigen.
4. Die 2. Funktionsebene
Der DiMAX Navigator bietet neben der Haupt
-
funktion zur Loksteuerung eine zweite Ebene
für verschiedene Funktionen. So kann man mit
dem Drehregler eine Lok steuern und zusätzlich
Weichen oder Fahrstraßen schalten oder sogar
eine zweite Lok steuern. Die zweite Steuerfunk
-
tion des Handreglers wird mit den drei Tasten
unterhalb des runden Drehknopfs gesteuert.
3.5.6.
Saving the Loco configuration
Saving the loco configuration with M2 (OK)
will store the specifications permanently in
the Navigator. After turning on the system
again the configuration is still available. If the
configuration is saved with M3 (TEMP), the
configuration is stored temporarily only. This
means that the loco details are only available
until the system is shut off. When the Central
station is switched on again, these details
will not be available anymore. After saving
the configuration the Navigator will show
the standard driving screen automatically.
3.5.7. Deleting a loco address
Holding
M2
long (three seconds) will load the
loco configuration mode. The first configura
-
tion page provides a function to delete locos
that are not required anymore. Holding
M1
will delete the active loco from the Naviga
-
tor. Afterwards a new loco can be selected
with
M1
and
M2
and confirmed with
M3
.
4. The secondary function layer
Besides the standard locomotive control
with the dial knob, the Navigator supports a
secondary function layer for different functions.
This allows operating a locomotive with the
dial knob while turnouts or turnout routes are
controlled. Even a second locomotive can be
operated. The secondary function is controlled
with the three keys below the dial know.
Summary of Contents for DiMAX Navigator
Page 1: ...DiMAX Navigator ...