8
9
ASSEMBLY INSTRUCTIONS FOR BBQ WITHOUT CONDIMENT DRAWER
Product Description
Carton Identification
Product Part Number
Open the carton by removing the
shipping straps then slitting along both
ends. Cut the tape only by a small
amount in the middle, finish by lifting
the carton flaps with your hand.
Unpack the entire carton, this carton
will be used as a surface protector as
the cabinet is being built. Open the
carton as shown and place where the
BBQ will be assembled
NOTE:
Letters in the bracket after every screw, helps you identify the item number from the parts list on page 6, from the fastener kit.
Tools needed for assembly:
Crosshead screwdriver, 10mm A/F Spanner
Open the fastener kit, place to one side, 4 pcs screw (SS) M6x12 (item b) & 4pcs fibre washer (item c) for Hood Assembly.
Before commencing assembly, open the cartons and lay all of the components on the floor. Familarise them against the parts list on page 21, as some
of these instructions refer to this parts list.
NOTE:
When assembling the barbecue, ensure it is sitting on a flat surface.
1. 1) Remove the screws , nuts and the washers fastened to the Weight Plate.
2) Fix the weight Plate (item 32) under the base tray (item 1) with these 2pcs Screw M6*40 (item g) 2pcs washer, (item h) 2pcs Nut M6 (item f).
1
Screw M6*40
32
Washer
Nut M6
2. Assemble 1pc Front skirt (item 2) to the Base tray (item 1) using 2pcs Screw M6×12 (item a) from the fastener kit.
2
Screw M6*12
3. Assemble 1pc Left skirt (item 3) to the Base tray using 3pcs Screw M6×12 (item a) and 1pc Screw M5*10 (item d) from the fastener kit.
3
Screw M6*12
Screw M5*10
4. Assemble 1pc Right skirt (item 4) to the Base tray using 3pcs Screw M6×12 (item a) and 1pc Screw M5*10 (item d) from the
fastener kit.
Screw M5*10
4
Screw M6*12
Rear of the
barbecue
5. Assemble 4pcs Castors (item 5) to the Base tray using 16pcs Screw M6×12 (item a) from the fastener kit.
NOTE:
Assemble the casters and lock the rear castors before assembling the cabinet
Screw M6*12
5
Lock this castor
Locking the rear castors will steady the base.
Position the base with the locks facing outwards.
Lock this
castor
Front of the
barbecue
NOTE:
Here on going forward keep the screws loose until the cabinet structure is complete. This will greatly assist with positioning
the panels. Tighten all screws when cabinet is assembled.
6. Assemble the Left panel (item 6) and Right panel (item 7) to the Base tray using 4pcs Screw M6×12 (item a) from the fastener kit.
