VOYAGER 6020
- 29
GB
GB
6.13 Alternator maintenance
The alternator used on this model is the synchronous, self-
excited type with electronic voltage control. This model
alternator, without manifold and brushes, does not require
particular maintenance operations. The checks and periodic
maintenance is limited to removing any traces of damp and
oxidation which might damage it.
6.14 Battery maintenance
To start all the generator models it is recommended to
use an
45 A/h
battery for ambient temperatures above
0°C and
55 A/h
for lower temperatures. Before installing
a new battery it is important that it has been subjected to
a complete charging cycle.
At least once a month, check the level of the electrolyte
and if necessary top up with distilled water.
If the generator is not used for a long period of time, it is
advisable to disconnect the battery and store it in a dry
place with temperature higher than 10°C.
The positive terminal of the battery must be protected with
Vaseline to prevent corrosion and the formation of oxide.
If necessary, top up with distilled water.
If the battery is left completely flat for long periods of
time, there is a risk of irreparably damaging it.
For top-ups with sulphuric acid it is essential to use
already prepared solutions
The battery top-up operations with distilled water and/or
acid must be carried out wearing protective rubber
gloves and glasses to prevent accidental contact of
sulphuric acid with the skin.
In case of accidental contact, carefully wash the affected
part with soap and water and consult a doctor.
Before proceeding with charging the batteries, check
the electrolyte level and, if necessary, fill up with
distilled water. This operation must be repeated when
the charging cycle has been completed.
6.15 Period of inactivity
@
@
@
@
@
If the generator is not to be used for long time, do the
following operations.
• Change the engine oil.
• Clean the air filter.
• Disconnect the battery cables. We recommend you
recharge the battery every month in order to prevent it
from going completely flat which, sometimes,
compromises its integrity.
• Clean the outside of the generator, removing all dust
and impurities.
