ISTRUZIONI PER L’OPERATORE
Pagina 11
PROBLEM
CAUSE
FIX
The spreader does not open at
the selected opening position
Likely anomaly of linear actuator.
With empty hopper move linear
actuator (see pag. 36 of Display
User
manual
-
section
Diagnostics).
Replace
linear
actuator with original spare part if it
does not move at the button
pressure.
The foward speed is not
detected
•
Cables are not connected
•
It have not been used the proper
connector with ISO11786 plug.
•
It has not beed chosen the
proper foward speed detection
type on the monitor
•
Make sure to have properly
connect the cables, try to
disconnect and connect it,
cleaning the connectors.
•
Try to connect the THEOR
SPEED connector or TRUE
SPEED connector.
•
Choose the proper speed
detector
type
in
tractor’s
handling menu.
Foward speed is incorrectly
detected
•
Using GPS Antenna there is the
possibility that in a restricted
area there is no service.
•
Using phonic wheel or ISO11786
plug it is possible that 100 m
calibration has not been done.
•
Try to change position on the
tractor of the GPS antenna
(position it on the tractor’s
cabin)
•
Try to move in another area to
see if foward speed is correctly
detected.
•
Carry out 100 m calibration as
indicated in user’s manual
The distributed quantity is not
equal to the one set on the
monitor.
•
Set work parameters are not
correct
•
It has not been carried out the
flux factor calculation (only for
machines
without
weighing
system).
•
Distributed fertilizer is very
different than the one choose on
the monitor
•
Set correctly work parameters
(spreading width, used fertilizer,
quantity to be spread).
•
In order to correct different
fertilizer features, on machines
without weighing system, it is
necessary to calculate flux
factor.
•
Carry out product calibration in
use as illustrated in machine
and monitor manual.
The weight in the monitor is
different than the fertilizer weight
inside the hopper
•
Possible incorrect flow factor
value (only on machines without
weighing system).
•
The tare was not performed or
the machine is not level (only on
machines with weighing system
•
On machines without weighing,
correct the flow factor as shown
above
•
On machines with a weighing
system, make sure that you
have performed the tare before
loading the fertilizer and that
the
weighing
frame
is
perpendicular to the ground
(see link the machine to the
tractor in the manual).
7. TROUBLE SHOOTING CHART (only for electronic machines)
