20
MAC III AirFX user manual
•
RDM UID
displays the fixture’s factory-set unique ID for identification in RDM systems.
•
FANS SPEED
provides separate status readouts from the fixture’s cooling fans.
•
TEMPERATURE
provides a fixture temperature status readout.
•
POWER UNIT
provides the following readouts:
-
MAINS VOLTAGE
displays a mains power voltage readout measured at the fixture’s mains power input.
-
LAMP VOLTAGE
,
LAMP CURRENT
and
LAMP WATTAGE
display readouts measured at the fixture’s
lamp terminals.
-
LAMP STATE
gives a lamp status readout.
-
IGNITER STATE
gives an igniter (starter) lamp status readout.
-
INTENSITY
indicates current lamp intensity.
•
EVENT LOG VIEWER
lets you view event logs in the fixture’s display panel. See “Event log” on page 32.
DMX signal monitoring
The MAC III AirFX provides data on the DMX signal it is receiving in the
DMX LIVE
menu. This information
can be useful for troubleshooting control problems.
RATE
displays the DMX refresh rate in packets per second. Values lower than 10 or higher than 44 may
result in erratic performance, especially when using tracking control.
QUALITY
displays the quality of the received DMX data as a percentage of packets received. Values much
below 100 indicate interference, poor connections, or other problems with the serial data link that are the
most common cause of control problems.
START CODE
displays the DMX start code. Packets with a start code other than 0 may cause irregular
performance.
The remaining options under
DMX LIVE
display the DMX values in a range from 0 - 255 that are being
received on each channel.
Test sequence
TEST SEQUENCE
activates effects in sequence, allowing you to test them quickly without a DMX
controller:
ACTION
lets you start, pause, and stop the sequence.
TYPE
lets you test all effects, pan/tilt movement only, or the other effects only.
REPEAT
sets the current test to repeat when finished.
Status readouts for the current test sequence are displayed below the
ACTION, TYPE
and
REPEAT
commands.
Manual control
The
MANUAL CONTROL
menu lets you reset the fixture, strike our douse the lamp, apply effects and move
pan and tilt manually.
Setup Wizard menu
The
SETUP WIZARD
menu gives quick access to the most frequently required items in the control menus.
Summary of Contents for MAC III AirFX
Page 1: ...MAC III AirFX USER MANUAL...
Page 62: ......
Page 63: ......
Page 64: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010...