Service and maintenance
31
Service and maintenance
Warning! Disconnect the fixture from power and allow to cool for 2 hours 45 minutes before
removing any cover.
Important! Excessive dust, smoke fluid, and particulate buildup degrades performance, causes
overheating and will damage the fixture. Damage caused by inadequate maintenance is not covered
by the warranty.
This section lists service and maintenance operations that may be carried out by the user. Refer any
operation that is not described here to a qualified Martin technician.
The MAC III AirFX requires routine cleaning. The schedule depends heavily on the operating environment. It
is essential to follow the cleaning guidelines given later in this section.
Tilt lock
Important!
Release the tilt lock before
operating the fixture.
The tilt position of the head can
be locked at various angles for
service. Push the lock in
towards the yoke in one
direction to lock the head and
back in from the other side to
unlock the head.
There is no pan lock on the
MAC III AirFX.
Important!
Release the tilt lock before
packing the fixture in the
flightcase.
Service utilities
The
SERVICE
menu in the main menu provides utilities for technicians rigging or servicing the fixture:
•
PAN/TILT FEEDBACK
lets you disable feedback to the fixture software from the pan, tilt and effects
positioning systems. If feedback is set to
On
and a pan, tilt or effect position error is detected, the shutter
closes and the effect resets. This feature can be disabled by setting feedback to
Off
.
The
Off
setting is not saved when the fixture is powered off, and the system will be re-enabled the next
time the fixture starts. If a pan/tilt position error occurs and the system cannot correct pan/tilt position
within 10 seconds, feedback is automatically disabled.
•
ADJUST
is for use at the factory and by authorized Martin Service technicians only. This menu allows
dimmer, shutter, pan and tilt positions to be adjusted after replacement of components, etc. To adjust the
default positions of all the MAC III AirFX’s effects, use the
CALIBRATION
menu instead.
Important!
Do not enter the ADJUST menu without service documentation from Martin.
• CALIBRATION
sets effects to their factory default positions or lets you set new default positions for
calibration purposes. See ”Calibration” later in this chapter for full details.
•
UPDATE FIRMWARE
, updates the firmware (fixture software). For a detailed guide to updating the
firmware, see ”Software installation” later in this chapter.
• EVENT LOG
gives access to the fixture’s log. See next section.
Figure 16: Tilt lock
Summary of Contents for MAC III AirFX
Page 1: ...MAC III AirFX USER MANUAL...
Page 62: ......
Page 63: ......
Page 64: ...www martin com Olof Palmes All 18 8200 Aarhus N Denmark Tel 45 8740 0000 Fax 45 8740 0010...