Troubleshooting
19
Troubleshooting
Problem
Probable cause(s)
Suggested remedy
Machine not at operating
temperature
Wait 5 to 7 minutes
set to 0
Increase setting
set to 0
Increase setting
Machine will not produce
haze when control panel or
remote control HAZE switch
turned on
DMX signal present
Disconnect or turn off DMX
controller
DMX address setting
incorrect
Change DMX address (page
13)
Machine can be fired from
control panel or remote
control, but not by DMX
controller
Poor connection in DMX line
Check DMX cables and
connections
Haze output is weak
Machine requires priming
Prime machine (page 13)
Incompatible haze fluid
Use approved fluid!
Wet, greasy, non-uniform
haze output, fluid drips or
spits from nozzle, or very
loud noise when firing
machine
Mains fuse blown
Replace fuse (page 18)
Machine appears dead
No power at AC cable inlet
Check power cable and
circuit breaker
Summary of Contents for JEM K1 Hazer
Page 1: ...K1 HAZERTM user manual P N 35010031 G...
Page 23: ...Notes 23 Notes...