8 Quick
Start
Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot
of haze. This section tells you how to do that. However, please also make the
time to read the safety and servicing instructions in the remainder of this
manual.
S e t t i n g u p
Locate the machine in a suitably large area with nothing in front of the haze
output.
Fill the fluid tank with MARTIN-approved haze fluid (see page 17).
Connect a suitably rated power supply to the machine. The power requirements
are:
6.3A at 230V (EU) or 10A at 120V (US)
If you are using the optional remote control, connect it to the REMOTE IN
connector on the rear panel.
Turn on the main power switch located next to the power cable inlet.
M a k i n g h a z e
Press either ECO / PRE1 / PRE2 from the Fast Access Mode on the onboard
control panel. If using the optional remote control, press the HAZE button. The
display will show
for about 5-7 minutes, once heated the machine will
start to produce haze at the selected level. If the machine is new or has run out
of fluid, page 13 ‘Priming the machine’ should be referenced.
S h u t t i n g d o w n
When you turn off the power, the unit will switch to its backup battery and enter
a 3 minute shutdown procedure. This clears the block of any residual fluid to
prevent clogging. During shutdown the display shows “WT” with a countdown.
Summary of Contents for JEM K1 Hazer
Page 1: ...K1 HAZERTM user manual P N 35010031 G...
Page 23: ...Notes 23 Notes...