14 Control
settings
Setting Run mod e
The Run menu sets the operational mode of the unit, either Off, Standby (heaters
remain on), Fan only, Timer mode or Continuous mode.
Use the Menu Previous / Next buttons to select the
option.
Use the Up/Down buttons to select
.
Press the Enter button to store the setting. The display shows
.
Selecting OFF will disable the heaters on the unit.
Setting Haze density
Use the Menu Previous / Next buttons to select the
option.
Use the Up/Down buttons to select the density from
–
.
Press the Enter button to store the haze setting. The display shows
.
If you want to temporarily change the haze density, do not
press Enter. The haze setting will go back to its stored
value next time the machine is powered up. This applies
to all options.
Setting Fan s peed
Use the Previous / Next buttons to select the
option.
Use the Up/Down buttons to select the fan speed from
–
.
Press the Enter button to store the fan setting.
The fan will run continuously if set above 0% and the RUN menu is set to FAN,
TIME or CONT.
If haze is being produced and the fan is off or set to a low speed, the fan speed
will be automatically increased to prevent build-up of haze at the machine output.
The fan will also automatically run on for a short period when haze is turned off.
Auto Fan Mode
In some circumstances where an improved vertical distribution of haze is
required,
can be selected from the
menu. This causes the fan
speed to vary over a 5 minute period.
Setting the Timer
Select the TIME option from the RUN menu.
Then set the TRUN and TOFF values from the menu.
The TRUN and TOFF values are set in seconds and are in the range 0-99. The
haze and fan values are taken from the menu settings for Haze and Fan. The
timer will cycle continuously until the run menu is changed.
Use this mode for maintaining a low level of haze in smaller venues.
When the timer is running and the display is not showing
a menu, the display shows TRUN or TOFF as the timer
cycles between run and off modes.