FIGURE 44
STEP 6
TESTING THE GARAGE DOOR OPENER SYSTEM
Press
the push button to open door. Observe that LED #5
OPNG illuminates as the garage door opens. The garage door
will stop when it reaches the full open position allowed by the
cable drums or optional bumper springs. Press the push button to
close the door. Observe that LED #4 CLSNG illuminates as the
garage door closes. The garage door will stop when it reaches
the floor. If OPNG or CLSNG light does not go out when door
stops, the belt tension may need to be adjusted (Max Power and
Close Sensitivity may also need adjusting). See Figure 43
Open
and close garage door two more complete cycles.
Observe the movement of the garage door as the computer
memorizes the open and close position. You may notice that
LED #1 ACK illuminates from time to time. The garage door
opener system now provides “soft start” and “soft stop” as the
door opens and closes. See Figure 43
Do Not
touch the following settings unless you are sure.
Force Setting
: MAX POWER is factory set at one o’clock. Force
can be slightly increased by turning screw clockwise 10 degrees
at a time. See Figure 10b, 43
Sensitivity Setting
: CLOSE SENSITIVITY is factory set at one
o’clock. Sensitivity can be increased by turning screw clockwise
10 degrees at a time. See Figure 10b, 43
Place
a 1 1/2”(38) high object (or a 2X4 laid flat) on the floor,
under the door. When the closing door contacts the object, it
should stop, reverse, and automatically return to the open
position. See Figure 44
If the door does not reverse, the drive belt may be slipping. After
correcting drive belt tension and the door still does not reverse,
call a trained Martin Door dealer. See Step 2
STEP 7
INSERT INSTRUCTION MANUAL INTO PACKET
Fold and Insert
instruction manual into the packet located on the
#3 door section of the Martin garage door or mount to the wall.
An Important
safety/instruction label is included with opener
package. This label and the instruction manual must be fastened
inside your garage where they can be easily seen. Fasten them
next to the wall control box. Peel off the protective backing, and
press onto smooth, clean surface. Tacks or additional adhesive
may be necessary. DO NOT REMOVE OR PAINT OVER ANY
LABELS. See Figures 45, 46
COPYRIGHT © 2008 MARTIN DOOR
15
FIGURE 43
FIGURE 46
!
8/2001
AD-01IM-03
INSTRUCTION MANUAL
For all Residential Garage Doors up to 12’ (3700) High.
G
GARA E
DOOR
N
OPE ER
S
IN TRUCTION
L
MANUA AND
N
WARI NG
L E
AB L
T
F
L
A
P
MAR IN INGER SHIE D G RAGE DOOR AND O
ENER SYSTEM
S
A
IN TRUCTION M NUALS AND WARNING LABEL
T
E
(FAC ORY PACKAG D AND MOUNTED)
CONTROL
BOX
ASSEMBLY
AND PUSH
BUTTON
MOTOR ASSEMBLY
TM
DOOR OPENERS
ARTI
N
M
FIGURE 45
A KET
P C
(F
T
M
N E )
AC ORY OU T D
L
D
FO D AN
IN
T
SER
IN
UC
N
STR
TIO
MANU
AL
INTO
KET
PAC
1 1/2”(38) HIGH OBJECT
FOR DOOR REVERSAL TEST
