M
OUNTING THE UNIT
4
1.
Place the Atomic 3000 DMX unit so that it is resting on its bottom edge as shown below.
2.
Using an 8mm AF wrench, carefully remove the lower, front, M5 ‘Taptite’ screws on sides of
the Atomic 3000 DMX.
3.
Loosen the top, front M5 ‘Taptite’ screws so that they protrude 5-6mm.
4.
Position the Atomic Colors in front of the strobe as shown with the top hooks resting on the
loose ‘Taptite’ screws. Align the lower front screw holes and replace the lower front screws.
5.
Tighten all screws.
6.
Rig Atomic 3000 DMX/Colors fixture and fasten the safety wires.
Note: The safety wire attached to the unit is designed solely for use with the Atomic
Colors unit. Use a separate safety wire for Atomic 3000DMX strobe
.
Attaching the ‘Atomic Colors’ unit to the ‘Atomic 3000 DMX’ strobe.
(For clarity, only one side of the units are shown)
Atomic Colors User Manual Mounting the unit
9