16
Ego user manual
rating is listed on the serial number label that can be found on the back of the
fixture.
5 Replace the fixture cover and tighten the access screws, taking care not to trap any
loose wires.
G O B O R E P L A C E M E N T O R R E M O V A L
( E G O 2 )
You can replace (or remove) the etched gobo in an Ego 2 with another aluminium
gobo that has:
•
An outside diameter of 22.5 mm + 0/- 0.3 mm (0.886 in. +0/- 0.012 in)
•
A maximum image diameter of 17 mm (0.669 in)
•
A maximum thickness of 1.8 mm (0.071 in)
To replace (or remove) the gobo:
1 Unplug the mains cable from the input socket.
2 Remove the six access screws from the cover and lift it off. The gobo holder is
located between the lamp and the mirror dish.
3 Remove the thumb screw on the gobo holder and lift it out to access the
interchangeable gobo holder.
4 The currently installed gobo can be pressed out of the holder gently with your
thumb.
5 If you a replacing the gobo, create a gap using a flat head screwdriver, and place
the new gobo in the holder.
6 Return the gobo holder to its normal position.
7 Replace and tighten the thumb screw.
8 Replace the fixture cover and tighten the access screws, taking care not to trap any
loose wires.
F I R M W A R E U P D A T E S
The installed firmware version can be displayed by the Trig LED on the control
panel when both the Dynamic and Idle Speed dials are wound fully clockwise and
power is applied to the fixture. The number of slow blinks indicate the software
version number to the left of the decimal place and any following fast blinks
indicate the software version number to the right of the decimal place. For
