Dip-switch SW2 Function
The dip-switch SW2 has 6 microswitches. Microswitch 2 is not used
The microswitch
1
is used to disable the loop fiber 2. This function is used when we use fiber
loop 1 only.
Microswitch 1 ON
=> Loop2 Disabled (Segment on Display on)
Microswitch 1 OFF
=> Loop2 Enabled (Segment on Display off)
The microswitches
3
,
4
,
5
and
6
are used to activate the control and calibration of the reading
of the fiber. This way you can be sure of the best read / signal transmission through the fiber.
Installation and Programming Manual V1.2
17
