2- Installation
___________________________________________________________________________
User Manual VS-541 – V01.0 Page 9 of 52 2/7/12
2.1 Connecting Network (LAN)
Connect the Power Adaptor to IP Camera
Connect Network Cable to Ethernet Port
To display video through Composite Port, after connecting each port to a monitor,
set
preview
option “ON” on the web-viewer page.
2.2 Connecting
Audio
Audio is Full-Duplex. It is possible to set the mode as Tx-Only, Rx-Only or Tx-Rx.
Connect Audio Input and Output Ports to audio devices accordingly.
The Audio Signal required is Line Level, so audio equipment with an amp, mixer or
other amplifier should be used.
2.3 Connecting Serial Ports
RS-485 on the IP camera can be connected to external equipment such as a PT
Receiver, etc. PC client can send PT commands to the external equipment via the
serial port. When a decoder system, instead of PC client, is connected to the IP
camera, the serial port and decoder system works in pass-through mode; data from one
port is delivered to the other port and vice versa.
2.4 Connecting Sensor and Alarm
Connect Sensor and Alarm Devices to corresponding terminals accordingly.
2.5 Connecting
Power
After confirming the Power Source, connect power adaptor and connect the 12VDC
connector to the IP camera.
2.6 Check if it Works
Once the power is supplied to the IP camera, it will start booting. The IP camera will
boot up to an operating mode after approximately 40-60 seconds. The green LED on
the Ethernet Port will flash indicating the IP camera is ready. Software provided on the
disc called VS Manager, allows you to check the IP address and other network details
of the IP camera. Please refer to the VS Manager manual for instructions on how to find
the camera’s IP address and details to modify if necessary.
