4- Remote Configuration
___________________________________________________________________________
User Manual VS-541 – V01.0 Page 43 of 52 2/7/12
Event Type
Three recording modes are supported:
Continuous
,
Event
,
Disconnect
. In case of
event recording, event types can be selected among several events. Selected event
type is used for configuring the schedule table. Up to 4 event types can be configured
and each event type can be a combination of sensor, video loss and motion event.
Pre-Event Time
Specify the duration of recording before an event happens.
Post-Event Time
Specify the duration after the event is cleared.
Schedule Table
Actual recording mode is determined by
Schedule Table
where recording mode is
configured by day (of the week) and hour.
Each Recording Mode configures the recording operation as shown below:
-
Record Off
: No recording.
-
Continuous
: Records continuously.
-
Disconnect
: Recording is started when the system loses the connection to its last
client (Decoder, VMS/NVR, etc). When there are multiple clients and one of the
clients is disconnected, this doesn’t happen.
-
Event Type
: Records when an event configured in the
Event Type
setting happens.
Checking Recording Status
Recording status can be viewed on the main
Live View
page.
Search and Playback
Recorded video and audio data can be saved as AVI format on the disk. In general,
one AVI file is created for an event-based recording. However, it is possible that
recorded data in a series of continuous events can be merged to a single AVI file
depending on the pre/post event time setting. The size of this continuous recording file
is limited to 10 ~ 200MB or 10 minutes.
Search
Actual recorded data doesn’t appear until it is completed. With continuous recordings,
a file will be shown after 10 minutes from the start of recording; a new file is generated
every 10 minutes.
