4- Remote Configuration
___________________________________________________________________________
User Manual VS-541 – V01.0 Page 35 of 52 2/7/12
When a Decoder is connected to an IP Camera instead of a PC Client, one system
becomes a
Local System
and the other a
Remote System
(generally the system
being used by the user is called the Local System). Actions can be configured for
Remote System Events
as well as
Local System Events
. For Example: It is possible
to turn on an alarm device in a local (center) decoder system when a sensor device in
remote (site) IP camera is triggered. Local section configures the actions for events
from local (self) system and this configuration activates local devices. Remote sections
configure the actions for events from a remote (peer) system.
The following table shows the possible
Event Actions
:
Action
Description
Alarm Out
Triggers Alarm (Relay) Port.
Sends Email to the Specified Address.
AVI File can be attached.
FTP
Upload AVI File to a Specified FTP Server
Preset
Move to the Preset Position
Local & Remote Event Configuration
Sensor
Configure the actions when the Sensor is activated. Multiple actions can be set for a
single event.
On Video Loss
Configure the actions when Video Input Signal is lost. Multiple actions can be set for a
single event.
On Motion
Configure the actions when motion is detected. Multiple actions can be set for a single
event.
On Disconnect
Configure the actions when the Link (connection) with Peer System is disconnected.
Multiple actions can be set for a single event.
Duration
Set the duration of an Alarm or Beep Activation in case of an Event. If set to
continuous, it will be active until an operator manually resets.
E-mail Notification
Specify the information to send when Email is selected as an Event Action.
Server Address
Enter an Address of the Mail (SMTP) Server.
