SOLO-NX
INSTALLATION MANUAL
Page 30
11
CHANGING PARAMETERS USING THE SMS
COMMANDS
All programming parameters for SOLO-NX can also be sent by SMS command. Each SMS
command should start and stop with semicolon. If the confirmation SMS is needed, put “+” at the
beginning of the command SMS.
The first SMS is SMS with telephone numbers (TN1 – TN4). If you would like to check which
telephone numbers are programmed in SOLO-NX please use the following command:
;PTN;
Return SMS is (example):
;TN1=0;TN2=0;
If you would like to enter telephone numbers in to SOLO-NX you can use the following example:
;TN1=040713470;TN2=+38643364850;
If you would like to receive confirmation SMS write “
+
” before SMS command:
;+TN1=040713470;TN2=+38643364850;
Return SMS from SOLO-NX is:
;TN1=040713470;TN2=+38643364850;
NOTE
You can use the same programming procedure for all parameters.
It is also possible to change different parameters with one SMS. Consider that the SMS message
should not be longer than
160 characters
(included space characters).
If you would like to change the following parameters
TN1, IN1, IN2, OS1, OS2; ID1, LN1 and
CRE
and would like to receive confirmation SMS, try next example:
;+TN1=+38640713470;IN1=1;IN2=1;OS1=15;OS2=1;ID1=120;LN1=1;
Send SMS message to SOLO-NX telephone number and in a few seconds you receive SMS
message from SOLO-NX. The sentence of the SMS must be the same as the one you have sent to
SOLO-NX before.
